ELECTRICITY
Page: 13
Reproductions or translations, even partial, are forbidden without the written consent of Peugeot Motocycles
To remove the ECU
Step 7
Important:
If changing the ECU it is essential to copy the ECU
parameters into the TEP 96 before disconnecting
the batteries
(see troubleshooting manual)
Remove the charger (see step 5)
Disconnect the power cables (1) from the batteries
and (2) from the motor to the ECU
Release and unclip the 37-pin connector (3) from the
ECU
Remove the 2 nuts (4) which also secure the charger
bracket (note fitting position)
Remove the ECU (5)
Check the 37-pin connection is in perfect condition.
The contacts must be properly aligned
The ECU must not be opened
Only the manufacturer is authorised to service this
component
Setting the throttle sensor
With the lever (1) in the rest position the sensor must
be against the stop (A) on the sensor body
if it is not in this position the machine will not start
Turn the throttle to fully open and check that the
sensor lever is in contact with the sensor stop (B)
