Petwalk Solutions GmbH & Co KG
User Guide
Page 36 of 88
Petwalk Solutions GmbH & Co KG
User Guide
Page 36 of 88
8.17
INSTALLATION OF FLUSH-MOUNTED POWER SUPPLY
For wall installation, we recommend using the optional in-wall power supply (not included in
the standard package, please order via our web shop). For installing of an in-wall power supply,
there are several ways which you should discuss with your electrician. The power supply can be
installed into a flush junction box, into the electric meter box or at the pet door. Subsequently,
we will only describe the installation at the pet door here.
.
Before you install the door an electrician needs to install the in-wall supply at the planned and
prepared location and connect it to the 230V mains. We recommend placing it above the tunnel
approximately 10 cm away from the opening. If there is not enough space available (e.g.
plastered mounting hole) and no other place between the tunnel and opening available, you
could use a blind socket nearby.
DANGER!
Electrical installations may only be performed by a qualified
electrician. Before starting to work on the electric circuit it must
necessarily be switched voltage-free before.
The mounted power supply unit must be connected to the AC side of the prepared 230V line.
During insertion of the outer flange with the plugged tunnel, you must ensure that the in-wall
power supply remains accessible.
On the inner frame you dig out the red cable from the groove (see number 17 in the previous
chapter). Cut the 24V connector from the cable. Once you have the two wires about 10 cm
separated, remove the insulation 5-7 mm. In the contacts of the connection cable, be sure to
observe the correct polarity. The wire to the black line is negative. You can even choose which
of the two negative connections you want to use. When connecting, make sure that the wires
from isolated or individual strands cannot touch.
The further installation is described in Section 18 of the previous chapter.
