Petsafe PWW00-14907, Руководство по эксплуатации

Страница: 9 / 16

www.petsafe.net 9
Fountain Reassembly
1. Attach the pump plate to the knob on the pump. ( Fig. 14)
Make sure the placement tab is on the top of the pump,
and press down to secure it in place. If the pump placement
tab is facing towards the outside of the bowl. You have it
backwards and need to turn it around.
2. With the pump plate properly attached, slide the pump into
place by placing the pump plate between the two slots inside
the bowl. (
Fig. 15) Press down to secure in place.
3. With the pump in place, the cord on the pump should be
facing the top of the fountain. Make sure the in-line plug is
disconnected from the adapter; feed the cord through the
small opening in the center of the bowl. ( Fig. 16)
4. Next, feed the cord through the bottom of the bowl until
there is no slack left in the cord. Press the cord into the cord
channel and feed through the cord notch. (
Fig. 17)
5. Replace the carbon filter. Rinse the filter thoroughly under
cold water before placing in the fountain. This will remove
any loose carbon dust, which is harmless. A small amount of
carbon dust may shed for the life of the filter. This is normal
and not harmful to your pet.
6. Insert the carbon filter. The filter will fit between the two
triangular slots to the right of the pump. Make sure it is
pushed all the way down and that the black side of the
carbon filter is facing toward the pump. (
Fig. 18)
7. Place the fountain in a desired location. To protect your
floor always use a protective mat, such as a towel or water
resistant placemat. This will help protect your floor from
splashing or spills caused by your pet.
8. Fill the fountain by pouring water directly into the bowl, this
will prime the pump. Leave at least 1/4 inch of space between
the water level and the rim of the bowl.
9. Attach the lid, press down until you hear it snap in place.
10. Before you plug in the fountain, make sure the electrical
power cord, the adapter and your hands are dry. Connect
the in-line plug and make sure no silver is showing, then
plug the adapter into a standard electrical wall outlet. ( Fig. 19)
11. Add water to the bowl as needed. Never let the water level
fall below 2 inches from the base of the bowl or you might
risk pump failure. Replacement pumps are sold separately
by calling the Customer Care Center at 1-800-732-2677
or visit www.petsafe.net.
Fig. 19
Fig. 18
Fig. 15
Fig. 16
Fig. 14
Fig. 17
Cord
Channel
Cord
Notch