Petsafe PIG00-11115, Руководство по эксплуатации

Страница: 20 / 36

1-800-732-2677 20
Cross Hard Surfaces (driveways, sidewalks, etc.)
• Concrete Driveway or Sidewalk (10C): Place the boundary
wire in a convenient expansion joint or create a groove using a
circular saw and masonry blade. Place the boundary wire in the
groove and cover with an appropriate waterproofing compound.
For best results, brush away dirt or other debris before patching.
•
Gravel or Dirt Driveway (10D):
Place the boundary wire
in a PVC pipe or water hose to protect the boundary wire
before burying.
Step 11: Place the Boundary Flags
The boundary flags are visual reminders for your pet of where the
warning zone is located.
1. Place the test light contacts on the contact points. Hold the
receiver collar at the height of your pet’s neck.
2. Walk towards the warning zone until the receiver collar
beeps (
11A
).
3. If you are in YardMax
®
mode (A) place the boundary flag
along the boundary wire approximately 6 inches inside the pet
area (
11B ).
4. If you are in Traditional mode (B) place the boundary flag where
you hear the beep (
11C
).
5. Walk back into the pet area until the beeping stops.
6. Repeat this process along the warning zone until it is marked with
boundary flags every 10 ft. (
11D
).
10C 10D
Boundary
Wire
YardMax Mode
11A
Boundary
Wire
Pet
Area
6”
11B
Boundary
Wire
Traditional Mode
11C
10 ft.
11D