Petsafe PIF17-13478, Руководство по эксплуатации и обучению

Страница: 13 / 169

www.petsafe.net 13
DE
NL
IT
FR
ES
EN
STEP 4
Adjust the Pet Area to Desired Size
Make sure the entire Pet Area lies within your property boundaries (
4A
). Always start
determining the Boundary Zone at the shortest distance from Transmitter. Place the
Boundary Switch on “High” for Boundary Zones more than 13.5 m from the
Transmitter. For Boundary Zones below this distance place the Boundary Switch on “Low.”
Test Light Instructions
1. Make sure the Receiver Collar Battery is properly charged. Set the Stimulation
Level to 2 or above.
2. Hold the Test Light Contacts to the Contact Points (
4B
).
3. Walk toward the Boundary Zone holding the Receiver collar at your pet’s neck
level (
4E
) until the Test Light flashes (
4F
).
Save Test Light for future testing.
Note: If your next-door neighbour has an In-Ground Containment system, see
Troubleshooting section page 23.
To maximize your Pet Area, make sure the Boundary Switch is on “High” and the
Boundary Control Dial is set to “8” (
4C
&
4D
). Plug Power Adaptor into Power Jack
and standard AC outlet.
Two-Person Method
Hold the Receiver Collar at your pet’s neck height (
4E
) with the
Petsafe
®
logo facing away from the Transmitter. Walk to the edge
of the desired Pet Area. Facing away from the Transmitter, hold the
Receiver Collar at the edge of the desired Pet Area (
4F
).
Starting with the Boundary Control Dial set to “8”, have a second
person turn the dial down SLOWLY. When the Receiver Collar starts
to beep, tell the person to stop turning the Boundary Control Dial.
Record your settings below for future reference.
One-Person Method
Measure the shortest distance from the desired Boundary Zone to the
Transmitter. Find the distance on the Transmitter Range Chart on page
13 and set the Boundary Switch and Boundary Control Dial. Hold
the Test Light Contacts to the Contact Points (
4B
). Take the Receiver
Collar to the Boundary Zone with the logo side facing away from the
Transmitter and Contact Points facing upwards (
4E
). Hold the Receiver Collar at your pet’s neck level (
4F
) until the
Receiver Collar beeps and the Test Light flashes. If the Receiver Collar beeps before or after the desired Boundary
Zone, return to the Transmitter and adjust the Boundary Control Dial. Repeat this process until the Receiver Collar is
beeping at the desired location. Record your settings on page 13 for future reference.
Pet
Area
STREE
T
4A
4B 4B
LOW
HIGH
4D
8
7
4C
4E
Pet
Area
Bou
ndar
y Zone
4F
4F