10
Customer Care Center 1-800-732-2677
STEP 2
prepare the receiver Collar
To Insert and Remove the Battery
1. Remove the screws with a small Phillips
screwdriver, applying adequate pressure for
the screwdriver head to fit snugly into the
screw. Remove the Battery Cover (
2A).
2. Install one (1), 3-volt (CR2) battery as shown
(
2B). Place the Battery Cover back into the
Receiver Collar. Note: Be sure the gasket on
the inside rim of the Battery Cover is intact
each time you replace it.
3. Reinstall the screws. Do not over-tighten the
screws.
Replacement batteries can be found at many
retailers. Contact the Customer Care Center or visit
our website at www.petsafe.net for a list of common retailers.
Risk of explosion if battery is replaced by an incorrect type. Do not short circuit, mix old
and new batteries, dispose of in fire, or expose to water. When batteries are stored or
disposed, they must be protected from shorting. Dispose of used batteries properly.
To Turn the Receiver Collar On
1. Press and hold the On/Off Button until the unit beeps and the Green LED light comes on. (This takes
approximately one second.)
2. Release the On/Off Button. The Green LED will flash once every 5 seconds, indicating the Receiver Collar is
on and ready to receive a signal from the Handheld Remote.
To Turn the Receiver Collar Off
1. Press and hold the On/Off Button until the unit beeps and the LED light shuts off. (This takes approximately
3 seconds.)
2. Release the On/Off Button. Note: To extend the life of the batteries, turn the Receiver Collar off when it is
not in use.
Important: If the Receiver Collar is left on continuously, the maximum battery life will be two weeks.
2A
2B
