Petsafe PCF-1000-20, Руководство по эксплуатации

Страница: 18 / 124

18 www.petsafe.net
Accessories
To purchase additional accessories for your PetSafe ® In-Ground Cat Fence ™ , contact the Customer Care Centre or visit
our website at www.petsafe.net to locate a retailer near you.
Component Part Number
Replacement Battery - Receiver Collar RFA-188
Power Adapter for the Fence Transmitter RFA-392
Replacement Collar RFA-254
Additional Receiver Collar PCF-275-19
Additional Boundary Wire RFA-1
Additional Boundary Flags RFA-2
Wire & Flag Accessory Kit PRFA-500
Additional Gel-Filled Capsules and Wire Nuts RFA-366
Fence Transmitter RFA-385
Accessory Pack (Extra Contact Points, washers,
batteries, battery lid, and Waterproof Seal) RFA-39
Troubleshooting
Receiver Collar is not beeping or
correcting. • Ch eck battery to make sure it is installed properly.
• Check that both lights are lit on the Fence Transmitter. If not, perform
the “Short Loop T est.”
The Receiver Collar is beeping, but
my cat is not responding to the Static
Correction. • Make sure that Static Correction Level is at 2 or above.
• Test the Receiver Collar with the Test Light walking toward the
Boundary wire.
• If the Test Light fl ashes, check the fi t of the Receiver Collar.
• Trim your cat’s fur where the Contact Points touch the neck and/or switch
to the longer Contact Points.
• Increase the Static Correction Level.
• Repeat training steps to reinforce training.
The Receiver Collar has to be held on
top of the Boundary Wire to activate. • Replace battery.
• Adjust Boundary Width Control knob clockwise to increase the distance
from the Boundary Wire that the Receiver Collar activates. You can also
adjust the Boundary Control Switch to another setting.
• If using a Double Loop, make sure Boundary Wires are separated 1 to 1.5 m
(3 to 5 ft).
• If the Receiver Collar still has to be held on top of the Boundary Wire,
perform the “Short Loop Test.”
The Receiver Collar activates inside
the house. • Turn the Boundary Width Control knob counterclockwise to decrease the
distance from the Boundary Wire that the Receiver Collar activates.
• Make sure the Boundary Wire is not running too close to the house. The
signal can transmit through the walls of your house.
• Make sure Boundary Wires are twisted from Boundary to the
Fence Transmitter.
I have an inconsistent signal. • Make sure Fence Transmitter is at least 1 m (3 ft) from large metal objects
or appliances.
• Make sure all Boundary Wire turns are gradual.
• Make sure the Boundary Wire is not running parallel to and within 1.5 m
(5 ft) of electrical wires, neighboring containment systems, telephone wires,
television or antenna cables, or satellite dishes.