8 1-888-632-4453
Cut the Fabric
Gather (Quantity):
• (5) Clips
• (1) Tension rod
1. Stretch the fabric as tightly as possible to the corner post and
select a fabric wire to cut, allowing 4 inches (10 cm) for the tension
rod and clips (
6A
).
2. Cut the fabric by holding the fabric loosely while you spin one of
the pickets out.
a. Undo the knuckle at the top and the knuckle at the bottom of the
same picket (
6B
).
b. Unweave that picket by spinning it out (
6C
).
Wire ends may be sharp.
c. Install the tension rod (
6D
) and 5 clips (
6E
).
Pinching may occur during fabric installation. Work
gloves are recommended.
Remove this picket
4
1
/
2
"
6A
6B
6C
6D
6E
Completing Fabric Installation
Repeat Steps 5-6
using the second roll of fence fabric. Start again at the other gate post. You will use
the remaining tension rods and 10 clips to complete these steps.
Secure the Fabric
Beginning at the gate opening, attach a tie wire to every
3rd diamond around the top (
8A
) and every 5th diamond
around the bottom (
8B
) of the kennel. Use any extra tie
wires around the bottom for extra security.
Note: Attaching tie wires around the bottom is easier if
you temporarily raise the bottom of the kennel onto bricks,
blocks of wood, or the box that the kennel came in.
Important: Please, for your pets safety, train your pet
to become accustomed to his new home. Consult a
professional for help.
8A
8B
Pet may escape or become trapped in loose chain link fabric. Be sure that the fabric is
stretched tightly and securely. If properly stretched, there should not be any slack in the fabric.
Step
6
Step
7
Step
8
