6 1-888-632-4453
Install the Gate Post and Gate
Gather (Quantity):
• (8) Clips
• (2) Gate Frame halves
• (1) Gate Chainlink Fabric
• (4) Tie Wires
• (1) PetSafe
®
Badge
1. Assemble Gate Frame halves together.
2. Slide tension bar into Chainlink and attach to one side of Gate Frame with 4 Clips.
3. Slide tension bar into Chainlink, pull Chainlink tight, and attach to other side of Gate Frame
with 4 Clips.
4. Secure the fabric with 4 tie wires. See Step 8 for details.
5. Place PetSafe
®
Badge on 3 diamonds from the top of the gate and center. Secure by bending tabs
onto Chainlink Fabric.
Gather (Quantity):
• (1) Tube G
• (2) Hinge clamp sets
• (2) Carriage Bolts and nuts
• (1) Spacer
• (1) Spring Button
6. Install Tube G 22 ¼ inches (57cm) on either side of the corner upright (Tube E). With the nut on the
outside, clamp Tube G to the top and bottom frame rails with Hinge Clamps and Carriage Bolts (
3A
).
7. Check that Tube G is straight up and down. Confirm that all nuts are tight.
8. Mount Spring Button into top Hinge Clamp. Secure gate between spring button and spacer (
3D
).
9. Add spacer over bottom Hinge Clamp (
3B
).
10. Mount gate into Hinge Clamps, sliding up into top clamp, then down over bottom clamp with spacer
(
3C
).
11. Install Gate Latch 3 feet (1 m) from ground (
3E
). Note: The Gate Latch can be locked.
Mount the
Gate
Lock not
provided
Mount
the
Spring
Button
Mount the
Spacer
Fix the hinge
clamps to
the kennel
with
bolts
3A
3B
3D
3E
3C
Step
3
