WALL MOUNTING
The flyDetect® trap has 4 keyhole slots on the rear panel to permit wall mounting, using the screws and
masonry plugs provided. The trap can be mounted either horizontally or vertically. Only 2 keyholes should
be used for horizontal mounting, whilst 4 keyholes should be used in vertical mounting for added stability.
Mark off the necessary fixing points onto the mounting surface using the paper mounting template
provided. Drill holes to a depth of 40mm using a 5.5mm drill bit. Place the plastic plugs into the wall, then
screw the screws into the plugs leaving the head of the screw approximately 10mm from the wall. The trap
will now hook over the screws using the keyhole feature.
If the wall is plasterboard, stud partition etc. suitable fixings should be used to ensure the trap will be
securely mounted.
CEILING SUSPENSION
The flyDetect® trap has the option of being ceiling suspended using the two brackets provided. These
brackets can accept a variety of mounting hardware such as suspension wire, or chains with spring release
clips and will provide a secure fixing point.
The ceiling suspension brackets should be attached one end at a time following the steps below.
1. Place the trap face down on a soft, debris free surface to avoid scratching the paint.
2. Using a pozi-drive screwdriver, remove the two screws and shakeproof washers holding the main cover
and internal chassis tray together, from one end of the trap only.
No ceiling suspension hardware is provided with this trap. The selected hardware should be
capable of supporting a minimum of 15kg and should be made from a non-corroding material.
If spring release clips are used, these should also be capable of supporting 15kg each.
8