3/98
Internal PS130 Power Supply Addendum
page 5
Internal PS130 Power Supply Addendum
2. Carefully push the power supply into the chassis until the power supply
connector makes initial contact with the backplane power connector. At this
point, firmly but carefully continue pushing the power supply into the equip-
ment chassis while making sure the power connectors are properly aligned.
You may have to slide the power supply latch toward the center of the supply
in order for the latch to move past the frame's metal work. Continue pushing
the power supply until the power supply slide lock clicks into the power supply
slide lock hole provided in the equipment chassis and the power connectors
are firmly mated.
3. If additional power supplies are to be installed in the equipment chassis, align
them with a set of power supply circuit card guides in the equipment item and
repeat step 2.
Fuse Replacement
*CAUTION*
DOUBLE-POLE/NEUTRAL FUSING
To replace the PS13O Power Supply line fuses take the following steps:
1. Disconnect the AC power cord from the power supply being ser-
viced.
2. Remove or open the front door of the equipment item containing the
PS130 Power Supply needing serviced.
3. Remove the power supply from the equipment item. Refer to the
Power Supply Removal Section of this addendum for power supply
removal instructions.
4. Carefully pull the AC line fuse holder open. The fuse holder is located
adjacent to the PS130 Power Supply AC line input connector.
5. Replace the fuses with fuses of equal current and voltage rating.
6. Carefully slide the AC line fuse holder closed.
7. Install the power supply back into the equipment chassis. Refer to the
Power Supply Installation Section of this addendum for complete
power supply installation instructions.
5. Reconnect the associated AC power cord.
