Permobil STREET, Руководство по обслуживанию, Страница: 32 / 60

Control panel & General Module
32
General Module
Removal
1. Remove the chassis covers; see page 7.
2. Undo the bracket which holds the General
Module in place. The bracket is attached with
two screws on the chassis, see illustration.
3. Lift the General Module and fixing from the
chassis. If necessary cut the bundling strip
holding the cables, but note its position for use
in refixing the cables.
The General Module is attached to its bracket
with two screws.
1
2
3
Cables for:
1. ICS Master Module
2. Seat lift motor
3. Soft pot.
The General Module’s bracket is attached with
two screws.
4. Remove the cabels from the General module,
see illustration.
5. Remove the General Module, which is
attached with two screws, see illustration.
Assembly
Assemble in the reverse order.
Control panel R-net
Removal
1. Switch off the main power switch on the
control panel.
2. Remove the cable ties holding the control
panel cabling in place under the arm rest. Note
the positions of the cable ties for subsequent
fitting.
3. Divide the control panel cabling at the contact
on the cabling.
4. Remove the control panel (1). It is held in
place with two screws (see illustration). These
two screws also hold the bracket for the ICS
control panel (2), if there is one fitted (see
illustration).
Assembly
Assemble in the reverse order.
The control panel is held in place with two screws.
1
2