Permobil ConnectMe M400, Руководство по обслуживанию

Страница: 32 / 80

32 32
Electric seat lift
Electric seat lift
Removal
1. Raise the seat to the highest position. If
the electric seat lift does not work normally
because the batteries are discharged or the
adjustment device is defective, the seat can be
raised/lowered manually. See page 31.
2. Switch off the main power switch on the
control panel.
3. Remove the upper chassis cover. See page 9.
4. Remove the seat including the seat tilt
mechanism if the wheelchair is equipped with
such device. See page 36-40.
5. If the wheelchair is equipped with seat support,
remove it. See page 36.
6. Remove the seat lift, it’s fitted with four screws
(see fig. below).
7. VR2
Separate the seat lift cabling at the contacts
on the cabling.
R-net
Disconnect the seat lift cabling from the ICS
general module.
8. Lift the seat lift straight up out of the chassis.
ICS General Module.
ICS General Module is fitted at
the rear of the chassis.
For this task the following tools are necessary:
1 Allen key 5 mm.
The seat is heavy. This work should therefore
always be performed by two people. Be careful
with the cabling.
m
WARNING!