Permobil Chairman Playman, Руководство по обслуживанию

Страница: 18 / 28

18
Pilot+ Power Module & SLS Driver
Pilot+ Power Module
Removal
1. Raise the seat to its highest position, see page 7.
2. Switch off the power using the control panel.
3. Put the circuit breaker in the “OFF” position,
see page 20.
4. Remove the seat lift and chassis covers,
see page 8.
5. Loosen the two screws used to mount the
power module, see fig. 34:2.
6. Lift the power module up.
7. Loosen the electrical connections to the power
module. Pay attention to the placement of the
contacts with an eye towards later remounting,
see fig. 35.
Fitting
Mounting is performed in the reverse order.
SLS Drive stage
Removal
1. Raise the seat to its highest position, see page 7.
2. Switch off the power using the control panel.
3. Put the circuit breaker in the “OFF” position,
see page 20.
4. Remove the seat lift and chassis covers,
see page 8.
5. Lift up the SLS box, which is sitting loose in its
holder, see fig. 34:1.
6. Pull the cover off the box.
7. Cut away the wiring bundle tie holding the
cables and loosen the electrical connections.
Pay attention to the placement of the contacts
with an eye towards later remounting.
8. Detach the circuit board from the case by
loosening the two fastening screws in the
middle of the card. Fixings in the form of
plastic clips can also occur.
Installation
Mounting is performed in the reverse order.
Refer to the diagram on the cover of the SLS box
for connections.
Fig. 34. SLS driver sits loosely in its holder.
Power Pilot+ fastened with two screws.
Fig. 35. Electrical connections for
the Power Pilot+.
Fig. 36. Electrical connections for the SLS Driver.
1
2