Permobil Chairman Playman, Руководство по обслуживанию

Страница: 17 / 28

Seat lift actuator
The working procedure is the same for both of
the seat lift’s actuators.
NOTE! However, the work for the left actuator can
be made easier if the seat is pushed forward
manually. Make sure when doing so that no cables
are stretched too tightly.
Removal
1. Run the seat lift up to its uppermost position
before releasing the seat lift, see page 7.
2. Detach the seat lift and chassis covers,
see page 7. Run the seat lift back down again.
3. Switch off the power using the control panel.
4. Put the circuit breaker in the “OFF” position,
see page. 20.
5. Cut away the wiring bundle ties fastening the
wiring for the actuator.
6. Loosen the wiring connections to the
actuator’s motor, see fig. 31. Note the
placement of the cables with an eye towards
their future remounting.
7. Unscrew and remove the two screws holding
the actuator, see fig. 32.
8. Unscrew and remove the screw holding the
clamping ring for the limit switch rod. Open the
clamping ring and detach it from the actuator,
see fig. 33:1.
9. Loosen the screws holding the limit switch kit,
see fig. 33:2-3.
10. Draw the actuator out.
Installation
Mounting is performed in the reverse order.
Seat lift actuator
17
Fig. 31. Cable connections for the actuator.
Fig. 32. The actuator’s base.
Fig. 33. Limit switch kit fastening points
1 2 3