PermaGreen Supreme E1E, Руководство оператора

Страница: 40 / 44

Service Manual 36
Adjusting engine speed to 3450 RPM
On a level open area free from obstructions and bystanders, lock
both Brakes, shift into
NEUTRAL , and start engine.
There are 2 methods to adjust the top engine speed.
Method 1 : If a small change in engine speed is needed, loosen
the jam nut on the Throttle Lever Adjuster.

To increase top engine speed to 3450 RPM :

Extend the Adjuster and check engine speed. Readjust as
necessary. Tighten Jam nut.

To decrease top engine speed to 3450 RPM :

Retract the Adjuster and test until the proper engine speed
is reached. Tighten Jam nut.
Method 2 : Reposition the Throttle Cable on the engine.

Remove the Air Filter and cover, and loosen the Throttle Cable
Clamp.

Tie, or have another person hold, the Throttle Lever tightly up
against the Hand Grip. Pull on the cable sheath until 3450 RPM
is reading on the Multifunction Display/tachometer. Tighten the
Cable Clamp.
After successfully adjusting engine Top speed, perform Safety
Device Test, 1 Throttle/Clutch/Operator Presence Control
PAGE 18
in the “Driver’s Training and Operation section of this manual.
Read Safety Manual WARNING 5 , Safety Devices before
starting or operating the Triumph.
Engine speed is part of the Operator Presence Control/
Throttle/Clutch Safety Device. Keep the top speed at 3450
RPM . DO NOT over-speed engine.
Replacing Throttle Lever

Remove Handgrip

Loosen Lever tensioning Screw

Remove cable

Replace Throttle Lever in reverse order
Replacing Throttle Cable

Remove Handgrip

Loosen Lever tensioning Screw

Remove cable

Replace Throttle Lever in reverse order
Operator Presence Control/Throttle/Clutch Adjustment & Service
Components: Throttle Lever, Throttle Cable, Auxiliary Throttle
Return Spring ( FIGURE 22 ), Multifunction Display (Tachometer),
Drive Belt, Idler Pulley, Idler Tension Spring, Transaxle, Honda
Engine and components: Honda carburetor and linkage, Honda
Governor Spring, Honda Throttle Spring, Honda Throttle Return
Spring, and Honda Clutch.
Read Safety Manual WARNING 5 , Safety Devices before
starting or operating the Triumph.
Adjusting Idle speed to 1650 RPM
Place machine in a level open area free from obstructions and
bystanders, lock both Brakes, shift into NEUTRAL , and start
engine.

To raise Idle speed turn Idle Adjustment Screw in.

To lower Idle speed , turn Idle Adjustment Screw out.
After successfully adjusting engine Idle speed, perform Safety
Device Test 1, Throttle/Clutch/Operator Presence Control, PAGE
18 in “Driver’s Training and Operation” section of this manual.
Idle speed is part of the Operator Presence Control/Throttle/
Clutch Safety Device. Keep the Idle speed less than 1650
RPM to avoid unexpected machine movement upon
starting.
FIGURE 21 , Adjusting idle speed
FIGURE 23 , Grease points
FIGURE 22 , Adjusting engine speed
Lubrication
IDLE ADJUSTMENT SCREW