Perle LINKSTREAM, Руководство по установке

Страница: 13 / 26

LINKSTREAM USER GUIDE
Page 13
1. Cold start the LINKSTREAM. This will clear any pre-existing
configuration and will put the unit in a known state of default
values.
2. Connect a terminal or PC running a suitable VT100 emulator
package such as Procomm or Hyperterminal, set to 9600 baud, 8
data bits, 1 stop bit, to the LINKSTREAM console port. Activate
the console port by typing <cr> so the LINKSTREAM> prompt
appears.
3. Type Quick followed by a <cr> to enter the Quick Setup Menu.
4. Enter the default password, which is 6 full stops: . . . . . .<cr>
5. When prompted for the Ethernet IP address, enter the value
from the worksheet. Note that an Ethernet IP Address must be
entered.
6. When prompted, enter the Subnet Mask. If subnetting is not
being used, accept the default value which is automatically set
to 255.255.255.0 for class C addresses.
7. To set Serial Link 0 with unnumbered IP addressing:
Serial Link0 Enable (on/off) [off]: on <cr>
Link0 Numbered or Unnumbered IP [numbered]:
unnumbered <cr>
8. If Serial Link1 is not used,
set Serial Link1 Enable (on/off) [off]:<cr>
9. If the worksheet states RIP is enabled, RIP (on/off) [off]: on <cr>
10. If the worksheet states no default gateway,
Default Gateway (x.x.x.x) [none]: <cr>
11. Voice Port0 is used, and is connected to Port0 of the remote
LINKSTREAM.
Voice Port0 (on/off) [off]: on <cr>
Port0 Type (Tie/FXO/FXS) [tie]L Tie <cr>
Port0 Remote IP Address (x.x.x.x) [0.0.0.0:192.168.2.45
Port0 Remote Port (0-3) [0]: 0 <cr>
12. If Voice Port1 is not to be used, Voice Port1 (on/off) [off] <cr>
If Voice Port1 is required, configure as above.
13. When prompted, save these changes and reboot (yes/no) [no]:
yes <cr>
The 'Saving settings' message will be displayed and dots will
appear as the parameters are stored. Within a few seconds the
LINKSTREAM will restart, and be ready for operation.
The configuration can now be 'fine-tuned' if necessary by using
the management screens.
SECTION 4.0 CONFIGURING YOUR LINKSTREAM