Appendix D - DIN Rail and Wall Mounting 32
IDS-509G Hardware Installation Guide
Wall Mounting the IDS
If you have purchased the optional wall mounting kit then proceed as below:
1. Remove the DIN rail clip from the rear panel on the IDS switch.
2. Attach the wall mount plates to the IDS switch as shown below using the screws pro
-
vided in the kit.
3. Use the wall mount plates as a guide to mark the spot where the screws will be placed.
4. Drive the screws into the wall leaving about 2 mm of the screw protruding from the
wall to allow room for sliding the wall mount panel between the wall and the screws.
5. Once the screws are fixed to the wall, insert the four screw heads through the large
parts of the keyhole shaped screw openings
6. Pull the IDS switch down to lock the IDS switch to the wall mount.
7. Tighten the four screws securely to the wall.
Note:
for best results use screws with the following attributes Head diameter .5 - .6 mm
Shaft diameter 3 -3.5 mm
Содержание 07014670
Страница 29: ...Appendix B Sample Labels 27 IDS 509G Hardware Installation Guide Appendix B Sample Labels...
Страница 30: ...Appendix C Mechanical Drawings 28 IDS 509G Hardware Installation Guide Appendix C Mechanical Drawings...
Страница 31: ...Appendix C Mechanical Drawings 29 IDS 509G Hardware Installation Guide...
Страница 32: ...Appendix C Mechanical Drawings 30 IDS 509G Hardware Installation Guide...
