Installation 20
IDS-509G Hardware Installation Guide
Connecting Data Ports
Ethernet Connections
By default all of the 10/100/1000 ports will automatically set themselves up to match the
speeds of all attached devices. If auto negotiation is not supported by one or more attached
devices, the ports can be configured to operate at fixed speeds and duplex settings.
Warnin
g:
In hazardous location installations, failure to remove the power from the source
prior when completing the wiring connections to the Ethernet ports could cause an electri
-
cal arc resulting in a possible explosion.
To connect to 10Base-T, 100Base-TX or 1000Base-T follow these steps:
1. When connecting to devices, workstations, servers or routers connect a straight
through Ethernet cable to a 10/100/1000 RJ45 connector on the front of the IDS
switch. Gigabit Ethernet requires CAT5 or better.
2. Once the device is connected and link is established the link LEDs will turn on. These
LEDs will indicate whether you have a 10,100 or 1000 Mb/s link to the switch. See.
(LED Indicators) for more details.
Note:
It may take a few seconds for the device to become active. By default the IDS
switch will have Rapid Spanning Tree (RSTP) protocol enabled. This protocol will first
check the network for any cabling loops prior to bringing the port up, in order to prevent
network disruptions.
Fiber Connections
To connect to 1000Base-X follow these steps:
1. Connect 1000Base-X devices to the fiber ports using appropriate fiber cables. Ensure
that cable implements the proper the TX to RX crossover
2. Once the device is connected and link is established the link LEDs will turn on.The
LED will begin to flash once data activity is initiated. See. (LED Indicators) for more
details.
Note:
It may take a few seconds for the device to become active. By default the IDS
switch will have Rapid Spanning Tree (RSTP) protocol enabled. This protocol will first
check the network for any cabling loops prior to bringing the port up, in order to prevent
network disruptions.
Содержание 07014670
Страница 29: ...Appendix B Sample Labels 27 IDS 509G Hardware Installation Guide Appendix B Sample Labels...
Страница 30: ...Appendix C Mechanical Drawings 28 IDS 509G Hardware Installation Guide Appendix C Mechanical Drawings...
Страница 31: ...Appendix C Mechanical Drawings 29 IDS 509G Hardware Installation Guide...
Страница 32: ...Appendix C Mechanical Drawings 30 IDS 509G Hardware Installation Guide...
