Perkins M92B, Руководство пользователя

Страница: 41 / 64

N37347 Chapter 4
Page 33
How to renew the canister of the lubricating oil filter
Warning! Discard the used canister and lubricating oil in a safe place and in accordance with local
regulations.
1. Clean thoroughly the outside surfaces of the oil filter.
2. Use a strap wrench or similar tool to just loosen the filter canister ( U1). Put a suitable container under
the filter assembly to retain spilt oil. Remove and discard safely the canister. Ensure that the adaptor (U3) is
secure in the lubricating oil cooler.
3. Clean the contact face of the lubricating oil cooler.
4. Lubricate the seal (U2) on top of the canister with clean engine lubricating oil.
5. Fit the new canister and tighten by hand until the seal contacts the cylinder block. Tighten the canister a
further 1/2 to 3/4 of a turn by hand only. Do not use a strap wrench.
6. Ensure that there is lubricating oil in the sump. Start the engine and run at idle speed until oil pressure
is obtained. Check for leakage from the filter. Stop the engine. After 15 minutes check the oil level on the
dipstick and, if necessary, put more lubricating oil into the sump.
Do not fill the sump past the notch on the dipstick.
Cautions:
• The canister contains a valve and special tube to ensure that lubricating oil does not drain from the filter.
• Therefore, ensure that the correct Perkins POWERPART canister is used.