Perkins M92B, Руководство пользователя

Страница: 35 / 64

N37347 Chapter 4
Page 27
How to renew the element of the fuel filter
Warning! Discard the used canister and fuel oil in a safe place and in accordance with local regulations.
Caution: It is important that only the genuine Perkins parts are used. The use of wrong parts could damage
the fuel injection equipment.
1. Thoroughly clean the outside surfaces of the fuel filter assembly (J 1).
2. Loosen the drain device (J2) at the bottom of the filter canister and drain the fuel into a suitable
container.
3. Turn the clamping ring (J3) to the left to free the filter.
4. Ensure that the inside of the filter head is clean
5. Ensure the locating nodes (J4) are in the correct position to slot into the filter head.
6. Turn the clamping ring to the right to lock in position.
7. Eliminate the air from the fuel filter.
Fuel pre-filter
This will normally be fitted between the fuel tank and the engine. Check the filter bowl for water at regular
intervals and drain as necessary.
Caution: Do not run the electric fuel lift pump for more than 60 seconds without fuel. The fuel pump can be
permanently damaged as it relies on the fuel for lubrication.