Perkins 403EA-11 Скачать руководство пользователя страница 15

Страница: 15 / 114

Ether is flammable and poisonous.

Lines, Tubes, and Hoses

Do not bend high-pressure lines. Do not strike high-

pressure lines. Do not install any lines that are bent

or damaged.
Repair any lines that are loose or damaged. Leaks

can cause fires. Consult your Perkins distributor for

repair or for replacement parts.
Check lines, tubes, and hoses carefully. Do not use

your bare hand to check for leaks. Use a board or

cardboard to check for leaks. Tighten all connections

to the recommended torque.
Replace the parts if any of the following conditions

are present:
• End fittings are damaged or leaking.
• Outer coverings are chafed or cut.
• Wires are exposed.
• Outer coverings are ballooning.
• Flexible parts of the hoses are kinked.
• Outer covers have embedded armoring.
• End fittings are displaced.
Make sure that all clamps, guards, and heat shields

are installed correctly to prevent vibration, rubbing

against other parts, and excessive heat.

i08162291

Crushing Prevention and
Cutting Prevention

Support the component properly when work beneath

the component is performed.
Unless other maintenance instructions are provided,

never attempt adjustments while the engine is

running.
Stay clear of all rotating parts and of all moving parts.

Leave the guards in place until maintenance is

performed. After the maintenance is performed,

reinstall the guards.
Keep objects away from moving fan blades. The fan

blades will throw objects or cut objects.
When objects are struck, wear protective glasses to

avoid injury to the eyes.

Chips or other debris may fly off objects when objects

are struck. Before objects are struck, ensure that no

one will be injured by flying debris.

i08159517

Mounting and Dismounting

Inspect the steps, the handholds, and the work area

before mounting the engine. Keep these items clean

and keep these items in good repair.
Mount the engine and dismount the engine only at

locations that have steps and/or handholds. Do not

climb on the engine, and do not jump off the engine.
Face the engine to mount the engine or dismount the

engine. With your feet and hands, always maintain a

three-point contact with the steps and designated

handholds. Do not use any controls as handholds.
Do not stand on components which cannot support

your weight. Use an adequate ladder or use a work

platform. Secure the climbing equipment so that the

equipment will not move.
Do not carry tools or supplies when you mount the

engine or when you dismount the engine. Use a hand

line to raise and lower tools or supplies.

i08614835

Before Starting Engine

NOTICE

For initial start-up of a new or rebuilt engine, and for

start-up of an engine that has been serviced, make

provision to shut the engine off should an overspeed

occur. This may be accomplished by shutting off the

air and/or fuel supply to the engine.

Engine exhaust contains products of combustion
which may be harmful to your health. Always
start and operate the engine in a well ventilated
area and, if in an enclosed area, vent the exhaust

to the outside.

Inspect the engine for potential hazards.
Do not start the engine if there is a

“

DO NOT

OPERATE

”

warning tag or similar warning tag

attached to the start switch. Do not move any of the

controls if there is a

“

DO NOT OPERATE

”