Illustration 61
g06010017
1.
Ensure that there is an adequate level of fuel in the
fuel tank. If equipped, ensure that the fuel supply
valve is in the ON position.
2.
Loosen the connector (1) and unscrew fuel pump
handle (4). Operate pump handle until fuel fee
from air flows from the connection. Clean up any
fuel that is spilled during fuel priming.
3.
Tighten connection (1) and loosen connection (2).
Operate pump handle until fuel fee from air flows
from the connection. Tighten connection (2). Clean
up any fuel that is spilled during fuel priming.
Operate pump handle (4) to increase the pressure
in the low-pressure fuel system.
4.
Push the handle and twist the handle to return the
pump handle to the locked position.
5.
Operate the starting motor and crank the engine.
After the engine has started, run the engine for a
minimum of 5 minutes to remove any trapped air
within the fuel system.
i06559454
Fuel
System
Filter
-
Replace
Fuel leaked or spilled onto hot surfaces or electri-
cal components can cause a fire. To help prevent
possible injury, turn the start switch off when
changing fuel filters or water separator elements.
Clean up fuel spills immediately.
NOTICE
Ensure that the engine is stopped and the battery is
isolated, before any servicing or repair is performed.
Fuel Filter with Water Separator
Table 17
Required Tools
Tool
Part Number
Part Name
Qty
A
-
Strap Wrench
1
1.
Isolate the fuel supply to the engine.
2.
Place a suitable container under the fuel filter to
catch any fuel that might spill.
Note:
Clean up any spilled fuel immediately.
70
SEBU9077-01
