Engine Starting
i02837427
Before Starting Engine
Perform the required daily maintenance and other
periodic maintenance before the engine is started.
Inspect the engine compartment. This inspection can
help prevent major repairs at a later date. Refer to the
Operation and Maintenance Manual, “Maintenance
Interval Schedule” for more information.
• Ensure that the engine has an adequate fuel
supply.
• Open the fuel supply valve (if equipped).
NOTICE
All valves in the fuel return line must be open before
and during engine operation to help prevent high fuel
pressure. High fuel pressure may cause filter housing
failure or other damage.
If the engine has not been started for several weeks,
fuel may have drained from the fuel system. Air may
have entered the filter housing. Also, when fuel filters
have been changed, some air pockets will be trapped
in the engine. In these instances, prime the fuel
system. Refer to the Operation and Maintenance
Manual, “Fuel System - Prime” for more information
on priming the fuel system.
Engine exhaust contains products of combustion
which may be harmful to your health. Always start
and operate the engine in a well ventilated area
and, if in an enclosed area, vent the exhaust to the
outside.
• Do not start the engine or move any of the controls
if there is a
“
DO NOT OPERATE
”
warning tag or
similar warning tag attached to the start switch or
to the controls.
• Reset all of the shutoffs or alarm components.
• Ensure that any driven equipment has been
disengaged. Minimize electrical loads or remove
any electrical loads.
i05298520
Cold Weather Starting
Do not use aerosol types of starting aids such as
ether. Such use could result in an explosion and
personal injury.
Startability will be improved at temperatures below
−18 °C (0 °F) from the use of a jacket water heater or
extra battery capacity.
When Group 2 diesel fuel is used, the following items
provide a means of minimizing starting problems and
fuel problems in cold weather: Engine oil pan heaters,
jacket water heaters, fuel heaters and fuel line
insulation.
Use the procedure that follows for cold weather
starting.
Note:
Do not adjust the engine speed control during
start-up. The electronic control module (ECM) will
control the engine speed during start-up.
Ensure that the correct oil specification, oil grade, and
the correct fuel are used before starting. Refer to this
Operation and Maintenance Manual, “Fluid
Recommendation”.
1.
Disengage any driven equipment.
2.
Turn the keyswitch to the RUN position. Leave the
keyswitch in the RUN position until the warning
light for the glow plugs is extinguished.
NOTICE
Do not engage the starting motor when flywheel is
turning. Do not start the engine under load.
If the engine fails to start within 30 seconds, release
the starter switch or button and wait two minutes to al-
low the starting motor to cool before attempting to
start the engine again.
3.
When the warning light for the glow plugs is
extinguished, turn the keyswitch to the START
position in order to engage the electric starting
motor and crank the engine.
Note:
The operating period of the warning light for the
glow plugs will change due to the temperature of the
engine.
4.
Allow the keyswitch to return to the RUN position
after the engine starts.
42
SEBU8731
Engine Starting
Before Starting Engine
Содержание 1106C-70TA
Страница 102: ...102 SEBU8731 Index Section...
Страница 104: ...2013 Perkins Engines Company Limited All Rights Reserved...