Peri MO-20-00445 0, Инструкция по сборке, пусконаладке и техническому обслуживанию

Страница: 6 / 80

6
RCS-2 Climbing Device and Hydraulics
Assembly Instructions
Introduction
These assembly instructions are not a replacement for the assembly instructions for
the hydraulic pump, hydraulic cylinder or complete climbing systems. The instructions
for the installed components and systems also apply.
Intended use
The hydraulic system, consisting of the
Climbing Device-2 RCS 50 in combination
with the Hydraulic Pump RCS MAX 2 x
210bar, 380-460V, is used exclusively for
lifting one climbing unit, consisting of
formwork and shoring structure, to the
next concreting section.
The hydraulic system cannot be used on
its own. It has been designed for installa-
tion in a climbing system.
PERI products have been designed for ex-
clusive use in the industrial and commer-
cial sectors only by suitably qualified,
trained and instructed personnel.
These Assembly Instructions serve as a
basis for the project-related risk assess-
ment, as well as instructions for the provi-
sion and use of the system by the con-
tractor (user). However, they do not
replace them.
The components are to be inspected be-
fore each use to ensure they are in per-
fect condition and that they function cor-
rectly.
Components provided by the contractor
must comply with the requirements stipu-
lated in these assembly instructions and
all applicable laws and standards.
Only PERI original components may be
used. The use of other products and
spare parts as well as different construc-
tional systems and modifications, repre-
sents a misapplication with a potential
safety risk. PERI shall not be held liable in
this case.
Changes to PERI components are not per-
mitted and represent a misapplication
with a potential safety risk.
Safety instructions and permissible loads
must be observed.
Deviations from the standard configura-
tions listed here are generally impermissi-
ble. Special applications must be de-
scribed in the form of detailed planning
and operating instructions based on a
separate risk assessment. These special
applications must be approved by PERI.
Anything other than the use that is speci-
fied in Point 1 is considered contrary to
the designated use!
For damage arising from non-intended
use
■
the operator bears sole responsibility,
■
the manufacturer assumes no liability.