Performer JC26-X, Инструкция по сборке

Страница: 6 / 16

6
Frame Alignment
1. Make sure the rear wheel is vertical to
ground and the front two wheels are
parallel to each other.
2. Picture 5 shows the front wheels OUT of
alignment towards the right. To correct
this, loosen the right two bolts and then
tighten the left two bolts. Reverse this
process for correcting a lean towards the
left. Once the frame aligned, carefully
tighten the four bolts in an alternating
pattern to avoid misalignment until they Pic 5
are fully tightened.
3. Run the tie rod below the frame and attach it to the tie rod
mounts. (Pic 6)
4. Measure the distance between the tires at both the leading edge
(Pic 7) and the trailing edge of the tires. (Pic 8)
5. Rotate the tie rod until the two measurements in step 7 are
equal.
6. Tighten the two tie rod locking nuts. (Pic 9)
Pic 6 Pic 7
Pic 8 Pic 9