11
PREPARING SCREW HOLES
– cont’d
5. If using a flat head screw, counter-sink
the hole (4) so the head of the screw
will be flush with the surface when it is
fully driven into place.
INSTALLING SCREWDRIVER BITS
WARNING:
Never hold the
screwdriver with your fingers near the
switch while changing screwdriver bits.
Accidentally touching the switch may
start the tool and possibly cause an
injury.
1. Select an appropriate screwdriver bit
that fits the head of the screw being
driven.
NOTES:
a) Use the largest size screwdriver bit that
will properly fit the screw head.
b) Make sure the screwdriver bit is in good
condition and is neither damaged nor
worn.
2. Insert the screwdriver bit (1) fully into
the magnetic bit holder (2) (Fig 9).
NOTE:
Make sure the screwdriver bit is
fully inserted into the magnetic bit holder
until it is held in place by the magnet.
ASSEMBLY & OPERATION
!
Fig. 9
Fig. 8
