3
IMPORTANT SAFETY INFORMATION
OPERATION
MAINTENANCE & INSPECTION
WARNING
READ, UNDERSTAND AND FOLLOW ALL INSTRUCTIONS AND WARNINGS BEFORE OPERATING THIS
TOOL. FAILURE TO DO SO MAY RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE AND WILL
VOID WARRANTY.
Warning:
Failure to heed these warnings may result in loss of load, damage to jack stands, and/or
jack stand failure resulting in personal injury or property damage.
Warning:
Do not overload jack stands beyond rated capacity. Overloading can cause damage to or
failure of the jack stands.
Warning:
POSITION LOAD ON CENTER OF SADDLE ONLY. ALWAYS USE STANDS IN PAIRS
ON HARD, LEVEL SURFACE CAPABLE OF SUSTAINING THE LOAD. USE OF STANDS ON
OTHER THAN HARD LEVEL SURFACES CAN RESULT IN STAND INSTABILITY AND
POSSIBLE LOSS OF LOAD.
Be sure all personnel are clear of load before lowering load.
Ensure that no personel pass underneath load until load is securely supported by jack stands.
1. Refer to your vehicle owner's manual for proper jacking procedures. Lift only on areas
of the vehicle as specified by vehicle manufacturer.-
2. Position stands under vehicle at points specified by vehicle manufacturer as proper
load support points.
3. To adjust stands: Hold control lever
up while lifting saddle shaft to
desired height. Push control lever
down to lock pawl into teeth
located in center column. MAKE
SURE PAWL IS FULLY
ENGAGED INTO TEETH.
4. Carefully lower load onto stands.
Saddle
Pawl
Center
Column
Control
Lever
1. Visual inspection shall be made before each use of the stands, checking for cracks,
cracked welds and missing and/or damaged parts. Any stand that appears to be
damaged in any way shall be removed from service immediately.
2. BECAUSE OF THE POTENTIAL HAZARDS ASSOCIATED WITH THE MISUSE OF
EQUIPMENT OF THIS TYPE, NO MODIFICATIONS SHALL BE MADE TO THE
PRODUCT.
