8
FIG. 13
Bottom
Rail Seal
3/4
″
(or 1/2
″
) long
Hex-head Screw
STEP 5:
INSTALL SUPPORT BRACKET
1. Hold each support bracket flush against outside of
sill & tighten to bottom of cabinet, as shown in Fig.
15A. Mark brackets at top level of sill and remove.
2. Assemble sill angle bracket to support brackets at
the marked position. (See Fig. 15B.) Hand tighten,
but allow for any changes later.
NOTE:
Check that air conditioner is tilted back about
1½
ʺ
to 1⅝
ʺ
(tilted about 3º to 4º downward toward
the outside). If, after proper installation, condensation
does not drain from the overflow drain hole during
normal use, adjust slope. (Fig 14)
FIG. 14
FIG. 15A
Mark
About 1
1
/
2
″
to 1
5
/
8
″
Window Sash
Side Louvers
Sill Angle Bracket
Window Sill
Measure from the
cabinet edge.
5
FIG. 15B
Right
Left
Locknut
1/2
″
Log Screws
and Locknuts
2 Each Required for
Each Support Bracket
Sill Angle
Bracket
Flat Head
Bolt
3. Install support brackets (with sill angle brackets
attached) to correct hole in bottom of cabinet, as
shown in Fig. 16.
4. Securely tighten all 6 bolts.
1/2
″
Long
Screws and
Locknuts
FIG. 16
STEP 6:
EXTEND WINDOW
ACCORDION PANELS
1. Carefully raise window to expose accordion panel
locking screws. Loosen screws so accordion
panels slide easily.
2. Extend panels to fill window opening completely.
Tighten locking screws on top (Fig. 17A).
3. Close window behind top angle.
Locking Screw
7/16
″
Locking
Screw and
Washer
FIG. 17A
