Press “Check
Filter” button
This feature is a reminder to clean the Air Filter for
more efficient operation. The LED (light) will illuminate after
250 hours of operation. To reset after cleaning the filter, press
the “Check Filter” button and the light will go off.
CHECK FILTER button
FOLLOW ME indicator light
To activate the Follow Me feature, point the remote control
towards the unit and press the “Follow Me” button. The remote
displays the actual temperature at its location. The remote control
will send this signal to the air conditioner every 3 minutes
until the “Follow Me” button is pressed again. If the unit does
not receive the “Follow Me” signal during any 7 minute interval,
the unit will beep to indicate the Follow Me mode has ended.
The actual temperature can be displayed at the unit by
pressing the “Fan” only mode. When in the “Cool” mode, the
unit display indicates the set temperature.
This feature can ONLY be activated from the remote control.
The remote control serves as a remote thermostat allowing for
precise temperature control at its location.
AIR CONDITIONER FEATURES (CONTINUED)
Light Flashing
Display
Evaporator
Temperature
Sensor Error
The control is capable of displaying temperature in degrees Fahrenheit or degrees Celsius. To convert from one
to the other, press and hold the Up and Down Temp/Timer buttons at the same time, for 3 seconds.
Error Codes:
AS
-
Room temperature sensor error -
Unplug the unit and
plug it back in. If error repeats, call consumer services.
-
Evaporator temperature sensor error -
Unplug the unit
and plug it back in. If error repeats, call consumer services.
(“ ” is displayed as shown in picture on right.)
HS
-
Electric heating sensor error
-
Unplug the unit and
plug it back in. If error repeats, call consumer services.
DISPLAY
Shows the set temperature in “°C” or “°F” and the Auto-
timer settings. While on “Fan” only mode, it shows the
room temperature.
ADDITIONAL THINGS YOU SHOULD KNOW
The Cool circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly. After unit
is turned off, leave unit off for a minimum of 3 minutes before attempting to turn back on. This prevents
overheating of the compressor and possible circuit breaker tripping. The fan will continue to run during this time.
Air Directional Louvers
HOW TO USE:
Check
Filter
Energy
Saver
Timer
Sleep
On Off
Fan
Mode
Low
Auto
Med
High
Follow
Me
Auto
Cool
Dry
Fan
If error code occurs in “Fan” only mode, unit will
display “LO” (loose connection) or “HI” (short circuit).
TEMP/TIMER
Check
Filter
Energy
Saver
Timer
Sleep
On Off
Fan
Mode
Low
Auto
Med
High
Follow
Me
Auto
Cool
Dry
Fan
The louvers will allow you to direct the air flow
left or right throughout the room as needed.
Move the levers from side to side until the desired
left/right direction is obtained.
Lever
8
TEMP/TIMER
Check
Filter
Energy
Saver
Timer
Sleep
On Off
Fan
Mode
Low
Auto
Med
High
Follow
Me
Auto
Cool
Dry
Fan
TEMP/TIMER
Check
Filter
Energy
Saver
Timer
Sleep
On Off
Fan
Mode
Low
Auto
Med
High
Follow
Me
Auto
Cool
Dry
Fan
