Perfect Aire 3PATW14002, Руководство пользователя

Страница: 8 / 28

5
HOW TO INSTALL
Do the following before installing the unit.
STEP 1:
IDENTIFY WALL-SLEEVE BRAND
Identify the wall-sleeve brand for your installation from the chart below.
WALL SLEEVE DIMENSIONS
BRAND WIDTH HEIGHT DEPTH
NOTE:
Please verify
dimensions of your
wall sleeve with its
manufacturer before
installing your thru-
the-wall unit.
PERFECT AIRE , Frigidaire, White-
Westinghouse, Carrier (52F Series)
25½" 15¼" 16", 17½", or 22"
General Electric, Hotpoint 26" 15⅝" 15⅞"
Whirlpool 25⅞" 16½" 17⅛" or 23"
Fedders, Emerson 27" 16¾" 16¾" or 19¾"
Sears/Kenmore, Carrier (51S Series) 25¾" 16⅞" 18⅝"
Fedders, Emerson 26¾" 15¾" 15"
Friedrich 27" 16¾" 16¾"
NOTE: All wall sleeves used to mount the new air conditioner must be in sound
structural condition and have a rear grille that securely attaches to sleeve, or
rear flange that serves as a stop for the air conditioner.
CAUTION: When the installation is complete, replacement unit MUST have a
rearward slope as shown.
STEP 2:
REMOVE OLD AIR CONDITIONER
Remove old air conditioner from wall sleeve and prepare wall sleeve as follows:
• Clean interior. (Do not disturb seals.)
• Wall sleeve must be securely fastened in wall before installing the air conditioner. Drive more nails or screws through
sleeve into wall if needed.
• Repair paint if needed.
STEP 3:
DRILL A ⅛" CLEARANCE HOLE
If not existing, drill a ⅛" clearance hole for grounding screw through left side of sleeve in a clear area about 3 inches
maximum (to suit) back from front edge of sleeve (as shown below) using ground screw and toothed washer. Pull loose
end of ground wire out front of sleeve, and temporarily bend it down and around lower edge of sleeve. The ground wire
will be attached to frame of air conditioner later once it is installed.
.
WALL SLEEVE TO UNIT
SLEEVE GROUNDING
3
"
MAX
1 "
1/8
"
HOLE
REAR
LEVEL
FRONT
UNIT
WALL
SLEEVE
1/4
"
to 5/16
"