Perfect Aire 2PTC12A-3.0, Руководство пользователя

Страница: 6 / 16

-5-
OUTDOOR GRILLE
(SOLD SEPERATELY
)
An outside grille must be installed to direct air flow for
proper unit operation and also protect the outdoor coil. The
grille must be installed before installing the chassis.
When replacing an old chassis with an existing grille or
using a specialized grille in a new installation, please
check with
supplier to determine if the new chassis
should be used with the nonstandard specialized grille.
An improper outdoor grille can decrease cooling or
heating capacity, increase energy usage and shorten
compressor life and possibly void the warranty.
2. Insert the chassis into the wall sleeve.
Wall Sleeve
Chassis
Flush Stamped Louver
Slide Chassis in Outside wall
Chassis Installation View 1
Architectural Louver
Wall Sleeve
Screws
CHASSIS INSTALLATION
1. Remove the cabinet front from the chassis as described
below (1a and 1b).
( 3 on each
side of unit
)
• Grasp the cabinet front.
Chassis
Outside wall
Chassis Installation View 2
3. Secure the chassis to the wall sleeve using three screws
on each side of the chassis to ensure a proper seal
between the chassis and the wall sleeve. The screws are
supplied in a plastic bag.
IMPORTANT NOTES:
Cabinet Front Removal View 1
•
Pull the bottom of the cabinet front away from the
chassis until the retaining clips disengage.
Cabinet Front Removal View 2
• Remove shipping tape from front panel as shown i n
Figure 12 on page 8
• Remove shipping screw from vent door as shown i n
Figure 13 on page 8.
1. The unit is equipped with a rubber grommet mounted
compressor. These grommets are factory set and require
no adjustment.
2. Check the indoor and outdoor grilles for obstructions to
air flow. The unit must be located where curtains, furniture,
trees, or other objects do not block the air flow to and from
the unit. If air is obstructed and/or deflected back into the
unit, the air conditioner compressor may cycle on and off
rapidly. This could damage the compressor or possibly
void the warranty.
• Slide the chassis into the wall sleeve until the chassis
flanges contact the front edge of the wall sleeve.