PERCo TTD-08A, Руководство по сборке и эксплуатации

Страница: 28 / 38

TTD-08A Electromechanical Box Tripod Turnstile
27
6. Remove the turnstile housing side cover (6), assembled with a top cover (8). In
order to do that:
•
Loosen two screws (1 in Fig. 15).
•
Take a side cover aside and detach a cable (8 in Fig. 12), connecting indication
blocks, from indication block IM1 (located under a top cover), and an indication
cable (7 in Fig. 12), from control block.
•
Remove a side cover and accurately put it on the straight stable surface.
3. Set up the housing on anchor bolt sleeves and fix it with the M10 bolts through
the holes in the post base.
4. Connect the power cable (13) to a connector block XS1 (Ref. Fig. 13).
5. Connect the cable of the RC panel (12) to a connector block XS1 .
Figure 15 – Layout of bracket cap-screws
7. If needed, connect cables from other devices to corresponding connector blocks of
control board.
8. If needed, install the board of outer controller ACS inside the turnstile housing on
the bracket (10 in Fig. 12); to do this, use clips with self adhesive foundations FSS-
5 from the delivery set.
6. If needed, install card readers on, specially provided for it, brackets on the housing
flanks (9 in Fig. 12). To ease the installation procedure, remove the bracket by
loosening two nuts M3 with an open end wrench S5,5, located below under the
bracket. To connect card readers use free contacts (15 - 24) of the remote
connector block
XS1.
Attention!
Possibility of PERCo card reader’s installation is anticipated in the turnstile
housing. With installation of third manufacturers readers they should correspond
with following technical characteristics:
overall readers dimensions ................................... not more than 135×90×30 mm
sensors read range ............................................................. not less than 50 mm
7. Check serviceability and accuracy of all the electrical connections.
8. Fix all cables with the help of self adhesive foundations and fixed brace rods from
the delivery set.
9. Put back side panels (6, 7), assembled with top covers (8, 9) in an order, opposite
to removal.
10. Put back a top cover (3) in an order, opposite to removal.
11. Run a test switch on of the turnstile as specified in Clause 9.1.
12. Check the work of the turnstile with RC panel, according to section 9.2 or 9.3
depending on a switched control mode.
After installation and testing have been completed, the turnstile is ready for operation.