PERCo CT/L-14, Руководство по сборке и эксплуатации

Страница: 28 / 58

CT/L-14 Controller
27
•
Protected zone is armed including the selected OD.
•
Passage through the OD (forced entry) sets the system into the “
Alarm
” mode.
11.2 Indication of ACM, events and controller configurations
Connected to the controller remote readers and indication blocks display the indication of ACMs,
states and responses of the controller upon presented identifiers. See Table 4 for possible
indication variants.
Note:
•
When reading an access control card in any operating mode, an audible signal of 0.2
seconds is performed, yellow indicator changes its state for 0.2 seconds. The state of
the other indicators is not changed.
•
After the access is granted, indication is turned on for Holding in unlocked state
period or until the passage is performed. When access is denied indication is turned on
for 1 second.
Table 4. Controller indication
Card presentation ACM
Indicators
Green Yellow Red Sound
Configuration is not selected No 5 Hz 5 Hz 5 Hz off
Activation of the
Fire Alarm
input
Any card
1.3/0.2
1
off off off
No
“Open” on off off off
“Control” off on off off
“Security” off 1 Hz 1 Hz off
“Closed”
off off on off
Card is not authorized for access
“Open”
on off off 0.2 sec
“Control”
off off on 0.5 sec
“Security”
Any card
“Closed”
Card is authorized for access
“Open”
on off off 0.2 sec
“Control”
“Security”
off off on 0.5 sec
Card is authorized for access and for
arming/disarming
“Open”
on off off 0.2 sec “Control”
“Security” 2
Re-presenting a
card with the right
to arming
Change to the
“Security” mode
“Security”
off 1 Hz 1 Hz 0.2 sec
In case of failure
3
(before to return to
initial mode)
“Open”
off off 1 sec 1 sec
“Control”
Waiting for verification Any off 2 Hz off 0.2 sec
1
Blinking (going off briefly) – 1.3 seconds is on, 0.2 seconds is off.
2
In the “ Security ” mode after presentation of access card with the right to disarming the following occurs:
OD disarming and OD unlocking for Holding in unlocked state period. After this time expires, the OD
switches to the operating mode set before OD arming (“
Open
” or “
Control
”, if the previous mode was
“
Closed
”, it will switch to the “
Control”
operating mode).
3
Sound and light indication turns on for 1 sec.