Instruction Manual peqPOWER 250 Volt Power Supply
Disinfection
In case disinfection gets necessary, clean the system with 70 % ethanol or IPA. After cleaning, ensure all
parts are dried thoroughly before attempting to operate the unit. Do not immerse the centrifuge in liquid
or pour liquids over it.
Before using any cleaning or decontamination methods except those recommended by the manufac-
turer, check with PEQLAB that the proposed method will not damage the equipment..
Replacing the Fuse
For additional fuses, contact PEQLAB’s Technical Service.
To replace the fuse:
1.
Turn off the main power switch at the rear of the peqPOWER 250 Volt Power Supply and de-
tach the power cord from the rear of the peqPOWER 250 Volt Power Supply.
2.
Open the fuse compartment located inside the Power Entry Module by inserting a small flat
blade screwdriver into the slot below the ON/OFF switch. Turn the screwdriver to gently pry
open the fuse compartment.
Note: The fuse compartment will not open with the power cord in place.
3.
Pull the fuse holder out of the compartment and inspect the fuse. If the fuse is burned or there is
a break in the fuse element, replace the fuse with an identical type of fuse (4A/250V) as pro-
vided in the fuse holder (see figure below).
4.
Place the fuse holder back into the compartment.
5.
Snap the cover closed.
PEQLAB_v0412E
14
