Peqlab EV200 Series, Инструкция по эксплуатации

Страница: 16 / 24

9. Enter the desired time and press SET (pre-set to [--:--]
if no timing is required)
ENTER
TIME UNIT:
h
10. Press RUN to start the experiment.
•
At any time, you can return in the stand-by mode by holding the SET but-
ton
for 2 seconds.
.
i t s
i
s
ENTER
TIME: 99:59h
•
At any time, you can avoid programming unnecessary parameters
To do so, s mply press RUN ins ead of SET after entering the la t relevant
value and the instrument will immediately start the experiment keeping the
other programmed parameters in memory.
RUN 1
∫
1 99:59h
400V 300mA 50W
•
To ensure that the des red parameter is kept constant, we suggest
to pre-set all other parameters to maximum.
•
A blinking unit of the controlling parameter appears when
the regulation is complete.
•
The timer will alway count down. However, when no time limit
has been programmed it will count up.
CHANGING PARAMETERS DURING A RUN
Only the parameters of the running step can be changed.
SET 1
∫
1 99:59h
400 300mA 50W
1. Press SET to change the parameters during the run with-
out interrupting it.
2. Change the actual voltage limit and press SET.
SET 1
∫
1 99:59h
400V 300 50W
3. Change the actual current limit and press SET.
4. Change the actual power limit, and press SET.
5. Change the actual time and press SET.
6. The power supply will now continue the run.
SET 1
∫
1 99:59h
400V 300mA 50
•
A gradient step can never be changed during a run.
•
Temporarily changed parameters are not kept in memory.other pro-
grammed parameters in memory.
SET 1
∫
1 99:59h
400V 300mA 50W
•
The instrument will automatically return to the run mode when no but-
ton has been pressed during 10 seconds.
PEQLAB Biotechnologie GmbH_V1107
14