Iss
u
e d
a
te
: 17
.4
.20
0
9
106
Subject to reasonable modifications due to technical advances.
© Fuchs, Printed in Germany
Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91
Internet http://www.pepperl-fuchs.com
AS-i 3.0 EtherNet/IP Gateway with integrated Safety Monitor
Operation in advanced display mode
If "Store" was successful, the LED "Config error" is turned off. The configuration is
stored and the configuration error has been eliminated.
However, if one of the connected slaves exhibits a peripheral fault, the LED "Con-
fig error" will flash.
If the AS-i master is in protected mode, the error message "Failed No Config
Mode" will appear:
Address 0 is not a permitted operation address for a slave. If an AS-i slave with
this address exists, storing the configuration will still be confirmed with "OK".
However, the configuration error remains.
9.9.4
FORCE OFFLINE (Switch AS-i Master to offline operation)
Main menu || SETUP ||
FORCE OFFLINE
||
This function is used to change the address of a slave.
With "Change", this status can be changed.
Switching the AS-i master to offline operation puts the AS-i network into the safe
state. The AS-i master must be offline if an AS-i slave needs to be readdressed
via the IR-interface.
9.9.5
AUTO ADDR ENABLE (enable automatic address)
Main menu ||
SETUP
||
AUTO ADDRESS
||
This function is used to enable or disable automatic single node address assign-
ment. This mode can be:
With "Change" the operation can be changed.
FORCE OFFLINE
NO
CHANGE
YES: AS-i Master is offline.
NO: AS-i Master is online.
AUTO ADDRESS
ENABLE
CHANGE
Enable: Automatic address assignment is released
Disable: Automatic address assignment is locked
