2-D Laser Scanner
Safety
2
0
1
6
-0
1
7
3
Safety
3.1
Symbols Relevant to Safety
3.2
General Safety Information
The following basic instructions must be observed at all times:
■
The device must not be commissioned until the manual has been read and
understood
■
The power supply to produce the supply voltage must have a safe electrical
isolation by means of double insulation and a safety transformer according
to DIN VDE 0551 (corresponds to IEC 742)
■
The device must not be used outside of its specification without suitable
protective measures
■
Modifying the device is not permitted
■
Do not point the devices in direct sunlight and do not take measurements in
sunlight
■
Do not remove the warnings or rating plates
Installation and commissioning of all devices must be performed only by
personnel specially trained for that purpose.
Protection of operating personnel and the system is not ensured if the product is
not used in accordance with its intended use.
The laws and guidelines applicable for the use or the intended purpose must be
observed. Devices are approved only for proper usage in accordance with
intended use. Ignoring these instructions will void any warranty and absolve the
manufacturer from any liability.
Use only recommended original accessories.
Danger!
This symbol indicates an imminent danger.
Non-observance will result in personal injury or death.
Warning!
This symbol indicates a possible fault or danger.
Non-observance may cause personal injury or serious property damage.
Caution!
This symbol indicates a possible fault.
Non-observance could interrupt the device and any connected systems and
plants, or result in their complete failure.
