12
Counting unit: seconds (the setting of the
decimal point determines the resolution).
Counting unit: minutes (the setting of the
decimal point determines the resolution).
Counting unit: hours (the setting of the
decimal point determines the resolution).
Counting unit: hours:minutes:seconds
(the setting of the decimal point is
ignored).
5.2.6 Counting unit
5.2.5 Operation of the GATE input
Counting runs when the GATE input is
OFF.
Counting runs when the GATE input is
ON.
A pulse on INP B starts the counting, the
following pulse on INP B stops it (raising
pulse edge for pnp, descending pulse edge
for npn).
A pulse on INP A starts the counting, a
pulse on INP B stops it (raising pulse
edge for pnp, descending pulse edge for
npn).
The counting can only be controlled by
means of the GATE input. INP A and INP
B have no function.
The counter is reset by a reset signal
(manual or electrical) (to 0 when adding,
to preset 2 when subtracting), then
counting starts. Counting is stopped when
the adding counting reaches preset 2 or
when the subtracting counting reaches 0.
A reset signal during counting also stops
the counting. INP A and INP B have no
function.
5.2.4 Start and stop of time counting
5.2.2 Polarity of the inputs
npn: switching to 0 V
pnp: switching to +24 V
5.2 Time meter mode setting
5.2.1 Sub operating mode
5.2.3 Activation of the 30 Hz filter
Electronic input dviving
Mechanical input driving
Adding
Outputs active at count value
⊕
preset
Resetting to zero
Subtracting
Output 1 active at count value
≤
preset 1
Output 2 active at count value
≤
0
Resetting to preset 2
Adding
Outputs active at count value
⊕
preset
Automatic reset to zero at count value =
preset 2
Resetting to zero
Subtracting
Output 1 active at count value
≤
preset 1
Output 2 active at count value = 0
Automatic positioning to preset 2 at count
value = 0
Resetting to preset 2
5.2.7 Decimal point setting
The decimal point determines the
number of decimal places displayed. It is
only used for displaying purposes and
has no influence on the counting.
0
no decimal place
0.0
one decimal place
0.00
two decimal places
0.000
three decimal places
Manual (using the red push-button) and
electrical resetting
No resetting possible (red push-button
and reset input idle)
Only electrical resetting
Only manual resetting
5.2.8 Resetting mode
5.2.9 Preset 1
Preset 1 activated
Preset 1 disactivated and without function
Subject to reasonable modifications due to technical advances.
Copyright Fuchs, Printed in Germany
Fuchs Group • Tel.: Germany (06 21) 7 76-0 • USA (330) 4 25 35 55 • Singapore 7 79 90 91 • Internet http://www.pepperl-fuchs.com
