Pepperl+Fuchs ECOM Ident-Ex 01, Руководство по эксплуатации

Страница: 6 / 12

6
Settings, such as the selection of the head module and the selection of the
module which reacts by pressing the Main Trigger or Trigger, will not be part of
the reset.
14. Reading with a head module
The head module which shall be used for reading can be chosen through the
settings. Also, the button which starts the reading of the head module can be
selected. The selected button starts the reading and sends the data with the
Bluetooth connected device.
While reading, the Scan LED blinks. When the reading was successful, the Scan
LED lights up for a defined timeperiod “setting in the Software Manual DOCT-
7016” and an accustic signal rings. (Can be deactivated through settings of
Ident-Ex => “Enable Beep”)
15. Bluetooth pairing of Ident-Ex
Switch on the Ident-Ex 01 to pair it with a device. The SPP and Bluetooth LED
must not illuminate. If the Bluetooth LED is illuminating, press the SPP Button
for approx. 2 seconds until the Bluetooth LED goes off.
Pairing with a PC:
Chose the Bluetooth name of the Ident-Ex 01 through “Start” -> “System control”
-> “Hardware and sound” -> “add Bluetooth device”
Pairing with a Smartphone or Tablet:
Chose the Bluetooth name of the Ident-Ex 01 through “Settings” → “Bluetooth”
Now, the device is paired with the Ident-Ex.
No pairing password is required because of the SSP-Mode
(Secure Simple Pairing) of the Ident-Ex 01.
16. Connection with HID-Profile
Autoconnect:
After switching on the Ident-Ex 01, the Ident-Ex 01 will automatically try to
connect with the last connected device with HID-Profile. The automatically
connecting process after start-up can be switched on/off in the settings (see
“HID autoconnect” setting in the Software Manual DOCT-7016).