15
5.
Maintenance and service
•
Periodically check joints, fixings and features to make sure everything is working properly and
not damaged.
•
Keep fabric and plastic parts clean with a damp sponge and gentle detergent.
•
To clean the mat, follow the instructions for use. The carpet in all cases has to be removed
before washing. Hand washable in water up to 30 degrees. Do not spin-dry or tumble-dry.
•
Do not use abrasives, bleach or any other harsh cleaning agents.
•
Parts of the mat may harden, squeak or become difficult to operate, in that case dirt or foreign
objects may have gotten into the structure. Remove it from the mat immediately.
•
Keep the play mat clean and let it dry after washing before using it again, to avoid mould growth.
•
Do not leave the mat in the boot of the car or in a place where it is exposed to direct sunlight for
long periods. When the mat is not in use for long periods, always store the product in a clean place
out of direct sunlight.
•
Direct sunlight may cause fading of the product.
•
If you have any problems with the operation of your play mat, contact the manufacturer or distributor
of the product directly.
6.
Battery replacement
WARNING! To avoid risks associated with battery replacement:
•
The batteries must be replaced by an adult.
•
Open the battery compartment cover with a screwdriver.
•
The product requires 3 x 1.5V AA batteries.
•
After replacing the batteries, put back the cover and screw it tightly with a screwdriver.
•
After replacing the batteries, check that they are inserted with the correct polarity.
•
Do not mix old and new elements, and alkaline with general elements.
•
Do not charge non-rechargeable batteries.
•
Do not charge batteries near heat sources (fire, electronic heaters, etc.)
•
Do not immerse batteries in water. Keep them clean and dry
•
If the music becomes quieter or skips, replace or recharge the batteries.
•
If the play mat does not need to be used for an extended period of time, remove the batteries from the
need for leakage.
•
Dead batteries must be removed from the product.
•
The power supply terminals must not be short-circuited.
•
Batteries must not be heated, this may lead to short circuits.
