SPACOMMAND
®
Spa-Side Remote Installation and User’s Guide
6
Step 3: Mount the SpaCommand
®
Spa-Side Remote
To mount the spa-side remote (recess mount with mud-box):
1.
Feed the remote wire into the mud-box conduit opening. Leave about eight
inches of wire slack out of the mud-box for installation. Pull the wire through
the conduit to the load center location. If needed use a “Fish Tape” or similar
method to pull the wire through long conduit runs with multiple bends.
2.
Mount the bracket:
Insert the remote wire connector through the bracket
opening. Mount the remote bracket onto the front of the mud-box.
Position the bracket:
Use the vertical screw hole slots to position the bracket
so that the top edge of the remote is level with the spa wall coping (see
diagram below). Align the bracket screw holes with the mud-box screw holes
and secure the bracket in place with the two screws.
3.
Connect the Cable Connector:
Place the O-RING over the round socket on
the rear of the remote. Insert the connector into the socket.
The connector is
keyed for the correct pin alignment. Be sure the connector fits flush
against the back of the remote front panel.
Secure the connector to the rear
of the remote with the two screws. Be sure that the wire in the mud-box is not
pinched.
4.
Place the remote onto the bracket. Press evenly on the bracket to secure in
place.
5.
Place the bezel on the front of the remote. Press evenly on the bezel to
secure in place. Note: The bezel comes in two colors; white and black. Be sure
to match the colors of the bezel and the remote front panel.
RECESS MOUNT INSTALLATION (with MUD-BOX)
Mud-box
Cable
connector
Bracket
Screw (x2)
Remote
(front panel)
Bezel
Screw (x2)
Note
: DO NOT install the spa-side
remote below the spa water level.
Remote (rear view)
O-RING
Screw (x2)
Connector
(keyed)
Socket
Spa wall coping
Use slots for vertical
bracket positioning
▼
▼
