P/N 520209
2
Rev. A 7-25-03
SECTION I.
APPLICATION
Used in conjunction with the IntelliTouch Pool/Spa Control System.
Provides switching of four remote control circuits from a wireless Hand-held Remote.
It is typically used for activating the spa circulation, and for operating three auxiliary pieces of equipment
(such as lights, jet pump, air blower, waterfall, etc.).
Each of the four functions on the Hand-held Remote has an "ON" and an “OFF” button.
SECTION II.
KIT INCLUDES:
1-qty.
Hand-held Remote (P/N 520018)
1-qty.
Receiver (with 9½ ft. cable)
4-qty.
Plastic Anchors (for mounting Receiver to concrete or stucco walls)
4-qty.
Mounting screws (for mounting Receiver to a flat surface)
SECTION III. HAND-HELD REMOTE
The Hand-held Remote will control four circuits.
Although the Remote is capable of duplicating any four circuits, it has been preset at the factory to control the
following:
Spa
Push-button activates the Spa circuit.
“A”
Push-button activates Auxiliary 1 circuit.
“B”
Push-button activates Auxiliary 2 circuit.
“C”
Push-button activates Auxiliary 3 circuit.
If you would like to control circuits other than Spa, Aux1, Aux2 and Aux3, it is possible to make adjustments
through the Indoor Control Panel or MobileTouch.
USING THE HAND-HELD REMOTE
To activate a circuit, press and hold the appropriate "ON" button for at least
a full second
. To deactivate, press
and hold the OFF button in the same manner.
IMPORTANT
The Hand-held Remote may be used with wet hands, but should never be submersed in water, as this could damage the
unit. If accidental submersion occurs, dry unit out by removing battery cover and removing battery. Position unit so that
water can drain out. Reassemble when completely dry.
