background image

Limited Warranty

PENTAIR warrants to the original consumer purchaser (“Purchaser” or “You”) of the products listed 
below, that they will be free from defects in material and workmanship for the Warranty Period 
shown below.

Product

Warranty Period

Water Systems Products — jet pumps, small centrifugal 
pumps, submersible pumps and related accessories

whichever occurs first: 
12 months from date of original installation, 
18 months from date of manufacture

Pentek Intellidrive*
Pentek* Solar Drive

12 months from date of original installation, or  
18 months from date of manufacture

Pro-Source* Composite Tanks

5 years from date of original installation

Pro-Source* Steel Pressure Tanks

5 years from date of original installation

Pro-Source* Epoxy-Line Tanks

3 years from date of original installation

Sump/Sewage/Effluent Products

12 months from date of original installation, or 
18 months from date of manufacture

Our warranty will not apply to any product that, in our sole judgment, has been subject to negligence, 
misapplication, improper installation, or improper maintenance. Without limiting the foregoing, 
operating a three phase motor with single phase power through a phase converter will void the 
warranty. Note also that three phase motors must be protected by three-leg, ambient compensated, 
extra-quick trip overload relays of the recommended size or the warranty is void.
Your only remedy, and PENTAIR’s only duty, is that PENTAIR repair or replace defective products (at 

PENTAIR’s choice). You must pay all labor and shipping charges associated with this warranty and 

must request warranty service through the installing dealer as soon as a problem is discovered. No 

request for service will be accepted if received after the Warranty Period has expired. This warranty 

is not transferable.
PENTAIR IS NOT LIABLE FOR ANY CONSEQUENTIAL, INCIDENTAL, OR CONTINGENT DAMAGES 

WHATSOEVER.
THE FOREGOING LIMITED WARRANTIES ARE EXCLUSIVE AND IN LIEU OF ALL OTHER EXPRESS 

AND IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO IMPLIED WARRANTIES OF 

MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. THE FOREGOING LIMITED 

WARRANTIES SHALL NOT EXTEND BEYOND THE DURATION PROVIDED HEREIN.
Some states do not allow the exclusion or limitation of incidental or consequential damages or 

limitations on how long an implied warranty lasts, so the above limitations or exclusions may not 

apply to You. This warranty gives You specific legal rights and You may also have other rights which 

vary from state to state.
This Limited Warranty is effective March 6, 2019 and replaces all undated warranties and warranties 

dated before March 6, 2019.

*For a detailed list of where Pentair trademarks are registered, please visit www.pentair.com/en/registrations.html. Pentair 

trademarks and logos are owned by Pentair PLC. or its affiliates. Third party registered and unregistered trademarks and 

logos are the property of their respective owners. Because we are continuously improving our products and services, Pentair 

reserves the right to change specifications without prior notice. Pentair is an equal opportunity employer. 

P1061 (03/06/19) ©2019 Pentair plc. All Rights Reserved.

293 Wright Street   

|

   Delavan, WI 53115   

|

   Ph: 866.973.6835  

|

   Orders Fax: 800.321.8793   

|

   pentair.com

Содержание Pentek PSD15

















Отзывы: