3
Installation
Instructions
After taking the above
precautions, lower the 12V
battery into the enclosure with the
terminals facing the front of the
Unit where the indicator lights
and battery cables are located.
At this time check the polarity of
your marine battery. Facing the
front of the Unit, the left battery
terminal should be positive and
the right, negative. If this is not
the case do not continue until the
proper battery can be obtained.
(Do not try to correct this problem
in any other way than by using the
proper battery.)
Functions and Lights:
1. With the pump plugged into the power cord receptacle, the power
cord plugged into a building receptacle:
A. Power loss (inverter on) light
OFF
B. Battery charging light
ON
C. Fully charged light
ON
2. With the pump plugged into the power cord receptacle, the power
cord plugged into a building receptacle, battery installed and
connected, RECEPTACLE POWER ON:
A. Power loss (inverter on) light
OFF
B. Battery charging light
ON
C. Fully charged light
OFF
D. (If fully charged, light)
(ON)
3. With the pump plugged into the power cord receptacle, the power
cord plugged into a building receptacle, battery installed and
connected, RECEPTACLE POWER OFF:
A. Power loss (inverter on) light
ON
B. Battery charging light
OFF
C. Fully charged light
OFF
D. (If fully charged, light)
(ON)
4. AFTER EACH 5 MINUTES OF OPERATION, the Unit halts
inverter operation for 5 seconds to test for receptacle power, pump
stops:
A. Power loss (inverter on) light
OFF
(may slowly dim)
B. Battery charging light
OFF
C. Fully charged light
OFF
D. If receptacle power is found to be present,
see # 2 above.
E. If receptacle power is found to be off,
see # 3 above.
5. If battery voltage falls below a usable charge, PUMP WILL STOP:
A.
Power loss (inverter on) light OFF
B.
Battery charging light
FLASH
C.
Fully charged light
OFF
6. Battery voltage may recover and allow brief periods of operation.
Now that the battery has been
installed with the terminals
nearest to the red and black wires,
PLUG THE UNIT INTO A 120V
OUTLET BEFORE CONNECTING
THE BATTERY LEADS. With
the Unit plugged into the 120V
outlet connect the battery leads
to the marine battery making
sure the red wire is connected to
the positive terminal and black
wire is connected to the negative
terminal. Make sure all battery
connections are properly tightened
to 75 inch pounds. Then place
the battery box cover back on
the Unit and strap it down so that
children cannot tamper with the
Unit. At this time you may plug
the high efficiency pump supplied
with the System into the back of
the piggyback plug on the Unit.
DO NOT PLUG ANY OTHER PUMP THAN THE PUMP
SUPPLIED WITH THE UNIT INTO THE UNIT. DOING SO
WILL VOID THE WARRANTY!
Содержание HYDROMATIC A+
Страница 6: ...6 This page intentionally left blank ...
Страница 7: ...7 This page intentionally left blank ...