Pentair CD-15G, Инструкция по установке и эксплуатации, Страница: 4 / 22

2
INTELLIZONE™ COMMERCIAL OZONE GENERATOR Installation and User's Guide
Electrical
Refer to the units specification label and local
electrical codes for information on proper electrical
connection.
120V Models
Main power circuit: Unit is supplied with a
standard power cord. Plug cord into standard
120V grounded, gounding type receptacle only.
230V Models
Main power circuit: 230V models are supplied
with an IEC 6032 C-14 Type power receptacle.
A power cord, having at least a 10AMP rating, with
a IEC 60320 C-13 Type plug and a country specific
plug is required to power generator.
Plumbing
Ozone gas is introduced to the circulation line using
a venturi in-line injector. Suction developed by the
venturi injector allows the generator to operate
safely under vacuum. See installation manual
for Model 521683 or 521684 for proper venturi
installation.
Ozone Gas Line
1. Connect ozone tubing to generator outlet fitting.
(3/8" stainless steel compression fitting.)
2. Connect opposite end of ozone tubing to injector
suction port. (Suction port fitting: 3/8" stainless
steel compression fitting.)
See Figure 4.
NOTE: The ozone gas supply line must be
made of PTFE or stainless steel and have a
back flow prevention device (such as a check
valve) installed between the ozone generator
cabinet and the point of injection to prevent
water from backing up into the generator
system. An ozone supply check valve is
included with the Model 521683 or 521684
system.
Figure 4: Plumbing Schematic - Example of Swimming Pool Application
Figure 3: Country Specific Plug
(Australia shown for reference only)