6
AQUALUMIN
®
III Nicheless Pool Light Installation Guide
4.
Before installing liner, be sure gasket is firmly attached to mounting hub. After liner is
installed and properly stretched into position, locate bolt holes in hub and punch liner for
four bracket mounting bolts.
Install the mounting spacer
against the liner and hold in
position with mounting bracket.
Secure with four (4) bracket
mounting bolts and washers.
5.
Wrap a length of the cord up to a
maximum of eight (8) feet long
on the back of the light
assembly. Wind a maximum of
three (3) wraps of cord so the
last wrap stops at the top of the
light. This extra cord allows you
to bring the light out of the pool
to install a new lamp and for
servicing.
NOTE:
Leave 2" to 3" of slack cord at the top so that the light may be tipped back for
removal.
6.
Feed the remaining cord through the conduit hole in the mounting hub. Place hook
mounting bracket over the pin on the bottom of the mounting bracket and press down
lightly to secure in place. Secure at the top of the light with the captive screw. When
installed properly, the housing spacer should fill any gap between the pool wall and the
light.
7.
Cut the cord at the junction box, leaving at least six (6) inches of cord to make
connections.
8.
Strip 6 inches of the outer cord jacket to expose the three insulated wires. Be careful not to
damage the insulation on the three inner wires.
9.
Connect cord to electrical wires at Junction Box, be careful to not pull the three (3) in. of
slack cord at the light through the conduit when connecting the wires. All wiring should be
connected to a Class A Ground Fault Circuit Interrupter (GFCI), in accordance with
electrical codes, see Section 1.A.1.a on page 3.
Figure 5.
Section 1: Installing a mounting bracket and light fixture during new vinyl
pool construction
(Continued)
