MicroBrite color led light for pool and spa Installation and User’s Guide
English
16
MAINTENANCE
REPLACING THE MICROBRITE® COLOR LED LIGHT ASSEMBLY
(IN AN EXISTING POOL OR SPA)
ELECTRICAL WIRING TO THE LIGHTING
MUST BE IN ACCORDANCE WITH THE
LATEST EDITION OF THE ELECTRICIAN WIRING RULES
(SEE P4).
IMPORTANT NOTICE:
THE MICROBRITE COLOR LED
LIGHT IS A NON-SERVICEABLE LIGHT. THE COMPLETE
LIGHT ASSEMBLY MUST BE REPLACED.
VERIFY THAT THE POOL AND SPA MEETS
THE REQUIREMENTS OF THE CURRENT
LOCAL REGULATION APPLICABLE. A LICENSED OR CER-
TIFIED ELECTRICIAN MUST INSTALL THE ELECTRICAL
SYSTEM TO MEET OR EXCEED THOSE REQUIREMENTS
BEFORE THE UNDERWATER LIGHT IS INSTALLED.
IMPORTANT NOTICE: The following removal and installa-
tion instructions describe how to remove and install the
MicroBrite light assembly.
Failure to bring the pool or spa’s electrical system up to code requirements before installing the underwater light
will create an electrical hazard which could result in death or serious injury to pool users, installers, or others due
to electrical shock, and may also cause damage to property.
1. Switch off electrical switch or circuit breaker at
the source.
2. Remove junction box or transformer cover.
Disconnect the light wires and attach a fish tape
to the existing light power cord. This will assist in
pulling the replacement light power cord through
the conduit back to the junction box.
3. Remove the MicroBrite light assembly from the
pool or spa water: Using the provided installa-
tion tool (P/N 602158Z), rotate the light assembly
counter-clockwise ¹/8 of a turn to release the light
from the wall fitting.
4. Slowly pull the light and attached power cord (with
attached fish tape) out of the wall fitting. Pull the
light’s power cord and fish tape out of the wall fit-
ting and place the light on the deck.
5. Attach the new light power cord to the fish tape
and carefully feed the fish tape and cable to the
junction box.
6. Install the light into the wall fitting: See page 6-9
for light installation instructions.
7. Connect the two (2) conductors to the corre-
sponding circuit wires in the junction box: See
page 4 and following for light wiring instructions.
8. Final check: See page 5 for final check instruc-
tions.
