P/N 840259
24
Rev. C 7-29-05
2. For operation by two remotely located toggle switch or automatic control buttons, (such as Compool
®
or
IntelliTouch
®
). See Figure 8 for proper setting of the toggle switches on bottom of the PG2000.
This application requires that four, minimum #18 gauge, wires be run to the unit (black/red/white/green).
Connect Black supply wire to Black wire in unit, Connect Red to Yellow, White to White and Green to Green.
Connect the Black wire to the Light Bulb power switch or relay and the Yellow/Red wire to the Color Wheel
power switch or relay. Provide a jumper wire from the load side of the Light Bulb switch or relay to the supply
(line) side of the Color Wheel switch or relay. This will prevent the color wheel from turning when the light bulb
is not turned on. For automatic control system such as Compool
®
, refer to the controller's manual to determine
which buttons operate the two relays.
A note about FreedomSynch
TM
PG2000's (840242) wiring and operation.
The wiring for these units is exactly the same as for all other PG2000s. Units can be connected in parallel or in series. All synchronization is self
contained within the unit’s electronics, and is locked to the 60 Hz AC power line. If there is more than 100 ft. difference between wire lengths of the
first and last PG2000 in a series, increase the wire gauge to reduce line losses that might prevent the synchronization circuitry from operating
properly once the colorwheels are turned on simultaneously, it will take about 1½ minutes for the colors to synchronize. Please refer to the Owner’s
Manual for proper operation of these models.
F. Carefully place outer body back onto the PG2000 and secure with two black #6 screws (previously set
aside) at the bottom.
G. Test functionality of unit.
NOTE
When cycling system off, then back on, it may take up to 3-4 minutes before the lamp "restrikes"
or comes back on. The lamp must cool down before restriking. All metal halide lamps have this
characteristic and this is a normal function of the PG2000.
PG2000 Dual Remote Switch
Wiring Schematic
Service
Panel
Black
Red
Green
White
Line
Neutral
Ground
2 Toggle Switches
or
2 Compool/IntelliTouch Relays
Yel
PG
PG
Yel
