Pentair Pool Products Nocchi R2T, Руководство по эксплуатации и обслуживанию

Страница: 10 / 24

B- If check-ups reveal the presence of abnormal conditions,
perform the operations described here below:
--
Refer to table “Problems/Causes" under "Operating
problems"
-- If the problem and cause is listed in table
“Problems/Causes” under “Operating problems”, contact
an authorised technician or a specialised technician and
report the abnormal condition found
-- If the problem and the cause is not listed in table
“Problems/Causes” under “Operating problems”, contact
an authorised technician or a specialised technician.
5.4 Extraordinary maintenance
Extraordinary maintenance operations performed after
problems, failures, breakage or technical updates should be
performed only by authorised or specialised technicians.
NOTE
PENTAIR WATER ITALY declines any
liability and cancels all warranty contracts
in presence of:
-
Operations not documented in this
manual and performed on the machine
- Extraordinary maintenance carried out by
others than authorised or specialised
technicians
6. OPERATING PROBLEMS
See table "Problems/Causes".
7. DEMOLITION
7.1 Machine disabling
- Cut the system off using the cut-off switch
- Close the gates on the suction and delivery lines
- Loosen the screws that fix the terminal block cover
- Disconnect the wires from the terminal block
- Remove the supply cable from the cable holder
- Remove the priming and drainage caps
- Allow all the fluid to drain from the machine
- Loosen the screws that fix the machine to the base
- Lift the machine as described under "Installation", "Lifting"
- Transport the machine as indicated under "Installation",
"Transportation"
- To re-use the machine, perform the following operations:
-- Reposition the terminal block cover with the related gasket
-- Tighten the screws that fix the terminal block cover
-- Close the delivery and suction holes to prevent dirt from
entering inside the machine
-- Store the machine as indicated in “Installation”, “Storage”
Danger If the temperature of the fluid that flows in
the pipes and circulates in the machine is
above 65 °C, install a protection around the
machine to protect it from high
temperatures
NOTE
PENTAIR WATER ITALY shall not be liable
of parts of the machine are recycled or re-
used
7.2 Residual risks after disabling
Warning
The machine has been manufactured with
non biodegradable materials. The machine
should be dismantled only in a deposit
equipped for these operations